Settings and recovery
Use this chapter when you need to configure, maintain, or recover EXCAP. These pages explain Tracker controls, binding, pairing, firmware, magnetometer calibration, haptics, placement, camera modes, and problem reports.
Tracker controls and status
Open Device to see Trackers connected through the USB dongle. This page explains the settings for...
Device shortcuts and joint binding
Use this page when you want Excap to assign body parts to the Trackers, or when you need one of t...
Pair Trackers
If all your Trackers already appear online in Device, skip this page. Pairing is for a new or rep...
Update firmware
Firmware updates use a direct USB connection. Update one device at a time and keep it connected u...
Magnetometer calibration
Open Setting → General. These switches control device-wide settings. The Tracker detail page has ...
Haptics and vibration
Open Setting → General and find Haptic. Haptics control Tracker vibration. They are separate from...
Tracker placement
Placement tells Excap which direction a Tracker faces on your body. It does not assign the Tracke...
Camera modes and shared setup
The camera Mode tells Excap how it receives and uses the external camera. You can choose a mode i...
Headset Mode camera setup
Headset Mode attaches the supplied camera to your headset and uses 2.4 GHz Wi-Fi to send the view...
Desktop Mode camera setup
Desktop Mode was proposed after version 2.0.0 and is experimental. Use it at your own risk. It is...
Report a problem
Excap has two different feedback paths: Use Help → Feedback for a suggestion or general comment. ...