Recently Updated Pages

简介 EMCAP上位机主要用于定位预览，参数设置，固件升级等。基站可以通过USB/WIFI的方式连接EMCAP上位机 硬件操作 基站 短按按钮开机，启动完毕后会亮起蓝色指示灯 长按按钮3s关机 ...

This chapter summarizes the planned firmware, hardware, software, and community features for EXCA...

This chapter explains additional setup tasks that are not needed every day. You will learn how to...

This chapter answers the most common questions about EXCAP, including product features, setup, co...

This chapter explains how to connect the EXCAP vision camera to your PC, configure it in Excap St...

This chapter shows you how to enable haptic feedback in VRChat. You will launch the Excap Space w...

This chapter explains the three tracking modes available in EXCAP. You will learn the differences...

This chapter covers the tracker-related options in Excap Studio. You will learn how to customize ...

This chapter covers how to use EXCAP with a standalone headset such as Meta Quest or Pico. You wi...

This chapter explains how to install Steam and SteamVR, launch Excap Studio in SteamVR mode, veri...

This chapter shows you how to connect your EXCAP trackers to the SlimeVR ecosystem. You will inst...

Your trackers are connected and Excap Studio is running. Now for the fun part — let's jump into V...

You did it! 🎉 Your EXCAP trackers are set up, calibrated, and ready to move with you in VR. This ...

Welcome to EXCAP! 🎉 Let's get your new trackers out of the box and ready for action. This page co...

Great — your trackers are out of the box and ready to wear. Now let's get Excap Studio installed,...

This is the official knowledge base for your EXCAP full-body tracking system — everything you nee...