Skip to main content

Download and Install

Download and Install

Great — your trackers are out of the box and ready to wear. Now let's get Excap Studio installed, the drivers ready, and your trackers powered on. ThisFollow pagethe willfive havesteps youbelow and you'll be up and running in just a few minutes. 🚀

Step

📄1: Page: Download and Install 🔄 Last updated: July 13, 2026 © 2026 Elecholic Technology. All rights reserved. 🔗 Official website · Downloads · Discord

Download Excap Studio

  1. Go to the Downloads – Elecholic page.
  2. Download and run Excap Studio.exe to install the software.

Step 2: Install the CH340 Driver

DownloadOn the same Downloads page, download and install CH340.exe. Even if you already have a CH340 driver installed, please install this specific version to avoid compatibility problems caused by older driver versions.

⚠️ Warning: The driver is required for the USB dongle to communicate with your PC. If the dongle is not detected, the trackers will not appear in Excap Studio.

Step 3: Launch Excap Studio for the First Time

Step 1: Double-click the Excap Studio shortcut to launch the application.

Build shortcut

Excap Studio will automatically check whether the SteamVR driver and the Excap Link USB dongle driver are installed. If either is missing, the software will install it for you.

Step 4: Connect the USB Dongle

Plug the included USB dongle into your PC and check the device connection information in Excap Studio. If the dongle does not appear, installgo back to Step 2 and reinstall the CH340 driver manually.driver.

USB Stick

💡 Tip: You can turn off every tracker at once by simply unplugging the USB dongle from the PC.

Step 5: Power On Your Trackers

Step

2: Press the button on each of the 8 EXCAP trackers. If the RGB lights turn on, the tracker is powered on successfully.

Step

3: Wait until all 8 trackers are listed in the Excap Studio interface.

Step 4: 

Shake or tap a tracker and confirm that its entry in the device list highlights in response.

Basic Operation

Action How to do it
Turn on Short press the button
Turn off Press and hold the button for 1 second, then release, or unplug the USB dongle
Charging RGB light breathes
Fully charged RGB light turns off

⚠️ Warning: Pressing and holding a tracker button for 5 seconds puts it into pairing mode. Be careful to avoid accidental long presses.

Basic operation

Tracker

⬅️ Previous page:Previous: Unboxing · Next page:Next: Enter Game and Calibration ➡️

Back to top